Thread: Zr1100
View Single Post
  #51  
Old 31-01-2018, 07:30 AM
HOS HOS is offline
Billy No Mates (only virtual ones!)
 
Join Date: Dec 2015
Location: England
Posts: 1,243
Default

I made some progress on the exhaust collar fix yesterday and a bit later I will share some photos of before and after. I used the Dremmel with a small cone shaped grinding wheel to finish off the larger diameter holes where I messed up with the drill. I'll need to drill out a couple of stainless steel washers to go between the sleeved nut and the collars and then the collars can be fitted after I've repainted them with silver vht paint.

It will look different to the other flanged nuts but it's a structurally sound solution and to me that is more important.

Last edited by HOS; 31-01-2018 at 07:34 AM.
Reply With Quote