PDA

View Full Version : cutting disks

Tom-madbiker
02-02-2005, 08:51 PM
has anoyone ever tried these super thin cutting disks (about 1mm thick) made by Kronenflex they are great :D
kitkatman
02-02-2005, 08:57 PM
kronoflex, is the what the enterprise is made off :D
manky monkey
02-02-2005, 09:11 PM
Bought some at the London Motorcycle Show at Ally Pally at the weekend. Half a dozen for a fiver! They ARE great, but I managed to shatter the first one by putting sideways pressure on it while cutting. No damage done but scared the life outa me! For very quick report on the show go to the link below & then Forums, Gallery or Forums, Messages. Can't remember which!
Also 5 part write up on the build of my mate's trike frame in New Stuff section & video clips of my old one in New Stuff 2004. :)
Tom-madbiker
02-02-2005, 09:13 PM
word of warning they do cut rather hot (just set fire to me shoelaces) :eek:
GSX Hooligan
03-02-2005, 12:59 AM
they're great mate, esp as at the minute they're free from work!

Mind you, try em on stainless and you only get one or two cuts per disk!
Peirre
03-02-2005, 04:43 PM
you should see the sight of 1 expoding mid-cut, :eek: :eek: :eek: especially after someones used it to grind a weld off, which it ain`t suposed to do, causing it to flex, get thinner, and eventually weaken.
don`t use cutting discs for grinding !!!! :eek:
manky monkey
04-02-2005, 06:16 PM
Ooops! :eek: