RebuiltYorkie
15-01-2006, 01:13 PM
Right I've said before, I've got the handbrake fitted to brake both rear wheels set up new position for lever, fitted it works well... Then I noticed after setting up /adjusting the rear brakes that both the cable and rod sections of the handbrake are resting/touching on the tail pipes when in full braked position.
I tried to set up a couple of small pulley wheels to act as steady's that push/keep both the cable and rod away from tail pipes, but this seems to push the cable, etc too low which means they could be damaged by debriss an' stuff, on the road..
Would/could this mean a fail? :(
PS the cable section dose have a outer metal cable sheath...cover? Coss she a bike trike handbrake will only be used at parking! No hill starts! :D
I tried to set up a couple of small pulley wheels to act as steady's that push/keep both the cable and rod away from tail pipes, but this seems to push the cable, etc too low which means they could be damaged by debriss an' stuff, on the road..
Would/could this mean a fail? :(
PS the cable section dose have a outer metal cable sheath...cover? Coss she a bike trike handbrake will only be used at parking! No hill starts! :D